Skip to content
Central air conditioner condenser behind a two-storey home
Homeowner guides

AC not turning on: what to check first

(647) 692-0819Open 24/7, day or night

AC not turning on means nothing happens when the thermostat calls for cooling: no fan, no hum, no click. The cause is often power, a thermostat setting or a safety switch that shut the system down for a reason. This guide covers the checks you can safely do in a few minutes, what the harder causes look like and when to book AC repair.

Request a technician

Tell us what’s going on. We’ll call to confirm a time.

What do you need?
How soon? Optional
Add email, details or text updatesOptional

Or call (647) 692-0819Used only to book your visit. Privacy

Key takeaways

  • Check the thermostat mode, setpoint and batteries, then the breakers and the furnace service switch.
  • A tripped breaker may be reset once. If it trips again, leave it off and call.
  • A full condensate drain can trip a safety switch that stops the AC on purpose.
  • Repeated breaker trips, burning smells or a humming outdoor unit mean stop and call a technician.
  • Our 313A-certified technicians quote a flat-rate price first, and we’re open 24/7.

Last updated . Written and reviewed by the Assurance HVAC Heating & Cooling service team.

On this page
  1. What AC not turning on actually looks like
  2. AC not turning on: start with the thermostat
  3. Breakers, the furnace switch and the outdoor disconnect
  4. A condensate safety switch that shut the AC off
  5. AC not turning on: causes by symptom
  6. When the outdoor unit hums or clicks but won’t start
  7. Control board, low-voltage fuse and wiring faults
  8. Signs to stop troubleshooting and call
  9. What a technician does when the AC won’t start
  10. Preventing AC not turning on next summer
  11. AC not turning on: common questions

What AC not turning on actually looks like

A central air conditioner has two halves, the indoor blower and the outdoor unit, and either can be the one that fails to start. Sometimes the whole system is dead, with a blank thermostat. Other times the indoor fan runs but the outdoor unit never starts, which is a different problem.

With AC not turning on, sorting out which half is silent tells you where to look and saves a technician time on the call.

  • Nothing at all: no sound from the furnace or the outdoor unit
  • The thermostat screen is blank or flashing
  • The indoor fan runs, but the outdoor unit stays still
  • The outdoor unit hums or clicks without starting

AC not turning on: start with the thermostat

Check the thermostat first, because it is the most common and easiest cause. Confirm it is set to Cool, the setpoint is a few degrees below the room temperature, and the screen is lit. A blank screen often means dead batteries, so replace them if the model takes batteries.

Some thermostats hold off for a few minutes after a power flicker or a quick off and on, a delay that protects the compressor. Give it five minutes before you decide it is dead. Our thermostat not working guide covers blank screens and wiring in more detail.

Breakers, the furnace switch and the outdoor disconnect

The AC needs power at two places, the furnace that holds the blower and the outdoor unit, so check both circuits. Find the breakers for the furnace and the air conditioner in the electrical panel and look for one sitting between On and Off. A tripped breaker may be reset once.

Flip it fully off, then on. If it trips again, leave it off and call, because a repeated trip means something is drawing too much current.

  • Furnace service switch: a light-switch style switch near the furnace. Flip it off, wait 30 seconds, then back on.
  • Outdoor disconnect: the box on the wall by the unit. Look at it, but don’t open it or pull anything out.
  • Panel: reset a tripped breaker once, and never go inside the electrical panel.

A condensate safety switch that shut the AC off

Many systems have a float switch in the drain pan or drain line. When the condensate drain clogs and water backs up, the switch cuts power to the AC so the water doesn’t overflow into your ceiling or floor. The system looks dead, but it is protecting the house.

Look at the drain pan or any condensate pump near the indoor unit. Standing water or a full pump is the sign. Don’t bypass or jump the switch, since it is there to prevent damage. A technician clears the line and tests the switch, and you can see why in our guide on AC leaking water.

AC not turning on: causes by symptom

Different symptoms of AC not turning on point to different parts of the system, and the table below pairs each one with its usual cause. Use it to decide whether to keep checking or to stop and call, since several causes involve live electrical parts that only a licensed technician should open.

Why an air conditioner won’t start, by symptom
What you noticeLikely causeWho fixes it
Blank thermostatDead batteries, tripped breaker or a blown low-voltage fuseYou first (batteries, breaker)
Nothing runs, drain pan holds waterCondensate float switch trippedTechnician
Indoor fan runs, outdoor unit silentOutdoor breaker, disconnect, contactor or capacitorYou first (breaker), then a technician
Outdoor unit hums, fan won’t spinFailed run capacitor or fan motorTechnician
Breaker trips again after a resetShorted wiring, failing compressor or motorTechnician
Thermostat set right, no responseWiring fault, failed thermostat or control boardTechnician

When the outdoor unit hums or clicks but won’t start

A humming or clicking outdoor unit that doesn’t start is trying to run and failing. The most common cause is a weak or dead capacitor, which gives the compressor and fan motor the boost they need to start. Left in that state, the motor can overheat or the breaker can trip.

Switch the AC off at the thermostat and leave it off. A capacitor holds an electrical charge even with the power off, so this is not a homeowner repair. Our guide on an AC outdoor unit not running explains the capacitor, contactor and fan motor in more detail.

Control board, low-voltage fuse and wiring faults

The thermostat talks to the furnace and the outdoor unit through low-voltage wires and a control board. A blown low-voltage fuse, a chewed wire, a failed transformer or a bad board can leave the AC dead even when every breaker is on and the thermostat is fine.

These faults often appear after a storm, renovation work or a new thermostat install, so tell the technician about anything that changed recently. Don’t open the furnace or the panels to look for them. Reading the board and testing each wire takes meters and training, and the status light code list is usually on a label inside the furnace panel or in the manual, and the technician reads it on site.

Signs to stop troubleshooting and call

Some signs mean you should stop checking and leave the AC off. A burning smell, a breaker that keeps tripping, visible scorching on the unit, sparks or a loud buzzing from the outdoor unit all point to an electrical fault that can get worse if the system is forced to run.

  • A breaker that trips again after one reset
  • A burning or electrical smell from the furnace or the outdoor unit
  • A loud hum or buzz without the fan turning
  • Water leaking from the indoor unit onto the floor or ceiling

Switch the AC off at the thermostat and book a visit. If you see smoke, flames or sparks, get everyone outside and call 911. We’re open 24/7, and technicians go out day or night for no-cooling emergencies.

What a technician does when the AC won’t start

For AC not turning on, a technician works down the power path. They confirm the thermostat call for cooling, check the voltage at the furnace and at the outdoor disconnect, test the safety switches and then the capacitor, contactor and motors, stopping at the first part that fails its test.

You approve a flat-rate price before any repair starts. Booked visits come with a two-hour arrival window and a text when the technician is on the way, and the work carries our written workmanship warranty. On an older system, they will also tell you honestly if the repair is worth it.

Preventing AC not turning on next summer

Most cases of AC not turning on come on the first hot weekend, when a part that sat idle all winter fails to start. Test the AC in spring, on a cool day, so you find out while appointments are easy to get, and change the filter so the blower and the drain stay clean.

A spring AC maintenance visit tests the capacitor and contactor, checks the electrical connections and clears the condensate drain, and the maintenance plan includes it with a fall furnace tune-up. The industry association HRAI (opens in a new tab) is a good place to learn more about the trade. If your AC is not turning on and is more than 12 to 15 years old, it is also worth asking whether replacement makes more sense.

FAQ

AC not turning on: common questions

Why is my air conditioner not turning on at all?

Start with the thermostat mode and batteries, then the breakers and the furnace service switch. If those are fine, a tripped condensate float switch, a blown low-voltage fuse or a failed control board may be stopping the system. If the checks don’t restore power, a technician should trace the fault.

Is it safe to reset my AC breaker?

Yes, once. Switch it fully off, then fully on. If it holds, the trip may have been a one-off surge. If it trips again, leave it off and call, because a repeat trip means an overload or a short, and forcing it can damage the compressor or wiring.

Why does my AC fan run but the outdoor unit won’t start?

The indoor blower and the outdoor unit are on separate circuits. If the blower runs but the outdoor unit is silent, check the outdoor breaker and disconnect, then suspect a failed capacitor or contactor. A humming unit that won’t start needs a technician, since capacitors hold a charge even when the power is off.

What is the safety switch that can stop my AC from running?

Many systems have a float switch in the condensate pan or drain line. When the drain clogs and water rises, it cuts power so the AC doesn’t flood the house. Never bypass it. Look for standing water and call a technician, who clears the line and tests the switch.

Can a thermostat battery stop the AC from turning on?

Yes. A thermostat that runs on batteries can go blank or lose its signal when they weaken, and the AC then has no call to start. Replace the batteries and check Cool mode. If the screen stays blank with fresh batteries, the wiring or the thermostat may be at fault.

Why does my AC not turn on after a power outage?

Most systems have a delay of a few minutes after power returns to protect the compressor. Wait about five minutes, then check the thermostat and breakers, since a surge can trip one. If the AC still won’t start, a blown low-voltage fuse or a damaged control board may be the cause.

Is a dead AC an emergency?

On a very hot day it can be, especially for infants, older adults and anyone with a health condition. Keep the house shaded, drink water and move to the coolest room. We’re open 24/7, and technicians go out day or night for no-cooling emergencies.

Who can fix an AC that won’t turn on in the GTA?

Our 313A-certified technicians repair central air conditioners in Toronto, North York, Richmond Hill, Vaughan, Markham, Mississauga and Oakville, on all major brands. Booked visits get a two-hour arrival window and a text, and you approve a flat-rate price before any repair begins.

Book a visit

Still no cooling? We’ll call you back to book a technician.

Send the form or call. You’ll get a confirmed arrival window and a price before any work starts.

(647) 692-0819

Open 24/7, with technicians out day or night for no-heat and no-cooling emergencies

Request a technician

Tell us what’s going on. We’ll call to confirm a time.

What do you need?
How soon? Optional
Add an email or detailsOptional

Or call (647) 692-0819Used only to book your visit. Privacy