Skip to content
Outdoor heat pump unit beside a brick house
Homeowner guides

Dual-fuel heat pump systems explained

(647) 692-0819Open 24/7, day or night

A dual-fuel heat pump system pairs an electric heat pump with a gas furnace, so the home uses whichever one suits the weather. The heat pump does the heating and cooling most of the year, and the furnace takes over in the coldest weather. This guide explains how it works, how the switchover is set, and the gas safety steps. For faults, see heat pump repair.

Get an installation quote

Tell us about your home. We’ll call to book a quote visit.

What do you need?
How soon? Optional
Add email, details or text updatesOptional

Or call (647) 692-0819Used only to book your visit. Privacy

Key takeaways

  • A dual-fuel system uses a heat pump for mild weather and a gas furnace for the coldest days.
  • A switchover temperature, set by a technician, decides when the furnace takes over.
  • It also cools in summer, because the heat pump works like an air conditioner.
  • The furnace brings gas safety rules: CO alarms and knowing the gas smell steps.
  • A system that won’t switch over needs a technician, not a DIY fix.

Last updated . Written and reviewed by the Assurance HVAC Heating & Cooling service team.

On this page
  1. What a dual-fuel heat pump system is
  2. How a dual-fuel heat pump decides which one runs
  3. How the switchover temperature is chosen
  4. Pros and cons of a dual-fuel system
  5. Dual-fuel heat pump or an all-electric setup?
  6. Adding a heat pump to your existing furnace
  7. Gas smell and CO alarm steps with a dual-fuel system
  8. A dual-fuel system that won’t switch to the furnace
  9. When the heat pump fails in a dual-fuel system
  10. Maintaining a dual-fuel system
  11. Rebates for a hybrid heating system
  12. Dual-fuel heat pump systems: common questions

What a dual-fuel heat pump system is

This is a heating system with two sources: an electric air-source heat pump and a gas furnace, sharing the same ducts and thermostat. It is sometimes called a hybrid system. The controls choose the source, so the house is heated by the one that makes most sense at that temperature.

The heat pump also cools in summer, replacing the separate air conditioner, and it uses the furnace’s blower and indoor coil.

How a dual-fuel heat pump decides which one runs

The system runs the heat pump while the outdoor temperature is above a switchover point, and the furnace takes over once it falls below. The point is called the switchover temperature, and a technician sets it on the thermostat or control board with the heat pump’s balance point and your energy rates in mind.

  • Above the switchover temperature, the heat pump heats the house
  • Below it, the furnace heats and the heat pump stays off
  • During defrost, the furnace can cover the cool spell briefly
  • In summer, the heat pump cools, like an air conditioner

How the switchover temperature is chosen

There isn’t one right number. The best setting depends on the heat pump’s output as it gets colder, the home’s heat loss, and the cost of gas and electricity. A technician sets it in the controls and can adjust it later if the bills or comfort show a better balance.

A lower switchover favours the heat pump, and a higher one favours the furnace. Ask your technician what’s set and why, and don’t change control settings yourself.

Pros and cons of a dual-fuel system

A dual-fuel system gives you efficient heating in mild weather, cooling, and a furnace that handles the cold. The trade-off is more equipment to maintain and a higher upfront cost than a furnace alone. The table lays out where it helps and where it adds complexity.

What a dual-fuel system offers and what it asks of you
Benefit or costWhat it means
Efficient heat in mild weatherThe heat pump does most of the work in fall and spring
Strong heat in deep coldThe furnace takes over, so output doesn’t drop with the weather
Cooling includedNo separate air conditioner needed
Two systems to maintainA furnace tune-up and a heat pump check
Gas stays in the homeCO alarms and gas safety rules still apply
Sizing for bothThe furnace and heat pump are matched to the same blower and ducts

Dual-fuel heat pump or an all-electric setup?

A dual-fuel setup keeps gas as the backup, while an all-electric setup uses a cold-climate heat pump, sometimes with electric backup. The choice turns on your panel capacity, your gas and hydro rates and how much you want to depend on one fuel. Neither is right for every home.

Read heat pump vs furnace for the wider comparison, and cold-climate heat pumps for the all-electric route.

Adding a heat pump to your existing furnace

If your gas furnace is in good shape, a heat pump can often be added to it, turning the system into a dual-fuel setup. A technician checks that the furnace’s blower and indoor coil suit the heat pump, that the ducts can carry the airflow, and that the thermostat and controls can manage both.

Older or mid-efficiency furnaces may not be a good match, and the furnace’s age matters. Our heat pump installation page explains sizing and fitting.

Gas smell and CO alarm steps with a dual-fuel system

Because a dual-fuel system includes a gas furnace, the gas safety rules apply every winter. Ontario’s Fire Code requires a CO alarm next to every sleeping area and, since January 1, 2026, on every storey of any home with a fuel-burning appliance, a fireplace or an attached garage. Know these steps before you need them, and tell everyone in the house.

  • Gas smell: leave the home right away without using switches or phones. Once you’re outside, call Enbridge Gas at 1-866-763-5427.
  • CO alarm sounding: get everyone, pets included, outside and call 911.
  • A burning smell from the furnace: switch it off at the service switch and call a technician.
  • Never open the burner compartment or touch the gas valve or internal safety switches.

The Ontario carbon monoxide safety page (opens in a new tab) explains where to put alarms and what to do when one sounds.

A dual-fuel system that won’t switch to the furnace

If the heat pump keeps running in deep cold and the house is cooling, or the furnace never starts, the switchover isn’t working. Causes include a sensor or control fault, a thermostat setup problem, a locked-out furnace or a failed relay. Heating suffers and costs rise while it goes on.

Check that the thermostat is in Heat mode with the setpoint above the room, and that the furnace service switch is on. If it still doesn’t switch, call. Don’t adjust internal controls yourself. A technician reads the control board, checks the outdoor temperature sensor and tests the furnace call to find the cause.

When the heat pump fails in a dual-fuel system

One benefit of a dual-fuel setup is that the furnace can carry the house if the heat pump fails. If the thermostat has an Emergency or Aux heat setting, switching to it tells the system to heat with the furnace until the repair is done. Don’t turn the whole system off in winter.

Read heat pump emergency heat for how the setting works, and our heat pump repair in Markham page for what we fix.

Maintaining a dual-fuel system

A dual-fuel system has two halves, so both need care. The furnace needs its yearly tune-up, with the flame sensor, venting, filter and CO check, and the heat pump needs its coils, fan, drain and refrigerant charge checked. Keep the outdoor unit clear of snow and leaves, and replace filters on schedule.

Our maintenance plan gives a heat pump seasonal checks for heating and cooling, with TSSA-certified gas technicians on the furnace side and 313A-certified mechanics on the heat pump.

Rebates for a hybrid heating system

Ontario’s Home Renovation Savings Program, delivered through Save on Energy and Enbridge Gas, supports some heat pump upgrades. Eligibility and amounts depend on your home and current heating fuel, and programs change, so we don’t quote figures. Our rebates page links the official program page.

Confirm that a dual-fuel setup qualifies before you commit, since the program sets its own equipment requirements. Ask the installer to put in writing which equipment, ratings and paperwork the program asks for, and keep the invoice and model numbers in a safe place.

FAQ

Dual-fuel heat pump systems: common questions

What is a dual-fuel heat pump?

It’s a heating system that pairs an electric heat pump with a gas furnace, sharing the same ducts and thermostat. The heat pump heats and cools while the weather is mild, and the furnace takes over below a switchover temperature. It’s also called a hybrid system.

At what temperature does a dual-fuel system switch to the furnace?

There’s no single answer. A technician sets the switchover temperature based on the heat pump’s output in the cold, your home’s heat loss, and gas and electricity rates. It can be adjusted later. Ask what yours is set to, and don’t change it yourself.

Is a dual-fuel system worth it?

It can be, for homes that want efficient heating and cooling most of the year with a furnace for the coldest nights. It costs more upfront than a furnace alone and means two systems to maintain. Your bills, your panel and the age of your furnace decide.

Can I add a heat pump to my existing gas furnace?

Often yes. A technician checks that the furnace blower and coil, the ducts and the controls suit the heat pump. Older or mid-efficiency furnaces may not be a good match, and the furnace’s age matters. A sized, matched installation is key, and the installer should explain which parts of the old system stay and which are replaced.

What do I do if I smell gas with a dual-fuel system?

Leave the home immediately without touching switches, lighters or phones inside, and bring everyone and your pets with you. Once you’re outside, call Enbridge Gas at 1-866-763-5427 and wait for their instructions. If a carbon monoxide alarm sounds instead, get everyone outside and call 911.

Why won’t my dual-fuel system use the furnace?

A control or sensor fault, a thermostat setup problem, a locked-out furnace or a failed relay can stop the switchover. Check the thermostat is in Heat mode and the furnace service switch is on. If it still stays on the heat pump in deep cold, call a technician.

Does a dual-fuel system still cool the house?

Yes. In summer the heat pump runs in reverse like an air conditioner and cools through the same ducts. That’s one reason many homeowners choose it, since one system replaces the separate air conditioner and also adds efficient heating in the shoulder seasons.

Who services dual-fuel heat pump systems in the GTA?

Assurance HVAC Heating & Cooling services both halves with TSSA-certified gas technicians and 313A-certified AC mechanics, across Toronto, North York, Richmond Hill, Vaughan, Markham, Mississauga and Oakville. We’re open 24/7, you approve a flat-rate price first, and all major brands are serviced.

Book a visit

Planning a replacement? We’ll call you back to book a quote visit.

Send the form or call. You’ll get a confirmed arrival window and a price before any work starts.

(647) 692-0819

Open 24/7, with technicians out day or night for no-heat and no-cooling emergencies

Get an installation quote

Tell us about your home. We’ll call to book a quote visit.

What do you need?
How soon? Optional
Add an email or detailsOptional

Or call (647) 692-0819Used only to book your visit. Privacy