
A heat pump making noise is not always a problem, because some sounds are part of normal operation, such as the whoosh of a defrost cycle. Others, like grinding, loud banging or a harsh buzz, mean a part is failing. This guide sorts the harmless sounds from the warning signs, lists what you can safely check, and explains when to book heat pump repair.
Key takeaways
- A whoosh, hiss and steam during defrost are normal, as is a low hum while running.
- Grinding, screeching, loud banging and a harsh buzz point to a failing part.
- Clear snow, leaves and debris from the unit, but never open it.
- If a loud fault noise starts, stop cooling, or use backup heat in winter if you have it.
- A technician finds the source, from fan motors and bearings to the compressor.
Last updated . Written and reviewed by the Assurance HVAC Heating & Cooling service team.
On this page
- Normal sounds from a heat pump
- The defrost whoosh and steam
- Heat pump making noise: buzzing and humming
- Heat pump making noise: grinding and squealing
- Heat pump making noise: banging and rattling
- Hissing, bubbling and gurgling
- What each heat pump noise usually means
- Noises from a ductless mini-split
- Winter noises: ice, snow and frozen parts
- What you can safely do about a noisy heat pump
- When heat pump making noise needs repair
- Keeping a heat pump quiet
- Heat pump making noise: common questions
Normal sounds from a heat pump
Every heat pump makes some noise, and most of it is harmless. The outdoor unit hums as the compressor and fan run, and the indoor head or air handler adds a soft rush of air. Knowing the usual sounds makes the unusual ones easier to spot, so a change in pitch or volume is what to watch for.
- A steady low hum from the outdoor unit while it runs
- A whoosh or hiss when a defrost cycle starts or ends
- Steam from the unit and water dripping during defrost
- A click when the system starts or stops
- The outdoor fan stopping for a few minutes during defrost
- Gentle air noise at the vents or indoor head
The defrost whoosh and steam
The sound that worries people most is the whoosh when a heat pump defrosts. It’s the refrigerant changing direction as the system briefly reverses to melt frost from the outdoor coil. The fan pauses, steam rises and a hiss follows, then everything settles and heating resumes.
That is normal in cold, damp weather and doesn’t mean a leak or fire. Our heat pump defrost mode guide explains the cycle and how long it should last.
Heat pump making noise: buzzing and humming
A low, even hum is normal, but a loud buzz or a hum that doesn’t lead to a start is a warning. Common causes are a failing run or start capacitor, a loose panel or part vibrating, a contactor that chatters, or a compressor struggling to start. Electrical buzzing is a reason for care.
If the outdoor unit hums but the fan doesn’t turn or the compressor won’t start, switch the thermostat off in summer, or to backup heat in winter, and call. Don’t open the unit or touch the wiring.
Heat pump making noise: grinding and squealing
Grinding or screeching usually means metal on metal: a failing fan motor bearing, a fan blade that’s hitting something, or a worn compressor. Squealing often points to a motor bearing running dry, or a belt on older air handlers. These sounds tend to get worse, so don’t leave them for weeks.
Shut off cooling in summer and call. In winter, use emergency or backup heat if your system has it. It costs more to run, so use it only until the repair. A failing fan motor can damage other parts the longer it runs.
Heat pump making noise: banging and rattling
A single bang at the start or stop of a cycle can be loose parts or ductwork expanding, but repeated banging inside the unit is a concern. Rattling often means a loose panel or screw, a bent fan blade or debris in the cabinet, and a hard clank can mean a failing compressor mount or internal part.
Look from outside the cabinet for sticks, ice or leaves near the fan guard, and clear what you can reach by hand with the thermostat set to Off. If the sound continues, call. Never reach through the guard.
Hissing, bubbling and gurgling
A short hiss at defrost is normal, but a steady hiss or a bubbling, gurgling sound while the heat pump runs can point to a refrigerant leak. Along with it you may see weak heating or cooling, ice on the lines and a system that runs constantly without keeping up.
Refrigerant leaks can’t be fixed by topping up. A 313A-certified technician finds the leak, repairs it and recharges the system to code. A gurgle from the indoor drain or a mini-split head can also mean a blocked condensate drain.
What each heat pump noise usually means
Matching the sound to a likely cause helps you describe it on the phone and decide how urgent it is. The table covers the common noises, and it’s a guide only, since a technician has to find the real cause on site.
| Sound | Likely cause | What to do |
|---|---|---|
| Whoosh, hiss and steam, then heat returns | Normal defrost cycle | Nothing, it’s normal |
| Steady low hum | Normal compressor and fan operation | Nothing, it’s normal |
| Loud buzz or hum without starting | Capacitor, contactor or compressor fault | Call |
| Grinding or screeching | Fan motor bearing or compressor wear | Stop cooling, call |
| Repeated banging or clanking | Loose or broken internal part | Call |
| Rattling | Loose panel, debris or a bent fan blade | Clear debris, then call |
| Constant hiss or bubbling | Possible refrigerant leak | Call |
Noises from a ductless mini-split
A mini-split has two sources of sound, the indoor head and the outdoor unit. The outdoor unit makes the same sounds as any heat pump. The indoor head can click as plastic expands, gurgle when the drain is partly blocked, or whistle when a filter is dirty or a louvre isn’t seated properly.
Clean or replace the washable filter as the manual shows, and check that the front panel is closed. Gurgling or dripping from the head means the drain needs attention, and grinding or banging means a fan or motor fault.
Winter noises: ice, snow and frozen parts
Winter adds sounds of its own. Ice on the fan blades can scrape the guard or make a rhythmic knocking, and snow or ice falling from the roof can hit the cabinet. A thick coat of ice that makes the fan labour is a sign the defrost isn’t clearing the coil.
Clear snow from the unit by hand or with a soft brush, and never chip at ice. Read heat pump frozen for what ice means, and don’t turn the system off in winter without backup heat.
What you can safely do about a noisy heat pump
The safe steps are simple and stay outside the equipment. They remove common causes like debris, snow and a dirty filter, and they help the technician when you call. Anything that involves opening a panel, touching wiring or the fan blades, or handling refrigerant is a technician’s job.
- Clear leaves, sticks, snow and debris from around and on top of the unit by hand.
- Check that the unit sits level and nothing is touching the cabinet.
- Replace a dirty indoor filter and make sure registers are open.
- Note when the sound happens, what it sounds like and whether it’s getting worse.
- Reset a tripped breaker once, and if it trips again, leave it off and call.
- If you smell burning or see smoke, stop the system at the thermostat and call.
If there is smoke or flames, leave the home and call 911 from outside.
When heat pump making noise needs repair
Call for repair when a noise is loud, harsh or getting worse, when it comes with weak heating or cooling, ice, a tripping breaker or a burning smell, or when the unit hums without starting. Early repair is cheaper than a failed motor or compressor.
Assurance HVAC Heating & Cooling repairs ducted and ductless systems across the GTA, including heat pump repair in Mississauga. You approve a flat-rate price before work starts, and we’re open 24/7.
Keeping a heat pump quiet
A well-kept heat pump runs more quietly. Keep the base level and on a solid pad or bracket, and have loose panels tightened and the coil and fan cleaned at a tune-up. Newer variable-speed models also run slower and quieter, since they rarely work at full speed.
Our maintenance plan includes two tune-ups a year. For an older unit that’s noisy and failing, read about heat pump installation, or see ENERGY STAR Canada (opens in a new tab) for efficient models.
Heat pump making noise: common questions
Why is my heat pump making a whooshing noise?
It’s almost certainly the defrost cycle. The system briefly reverses to melt frost off the outdoor coil, and you hear the refrigerant switch direction, often with steam and a paused fan. It’s normal in cold, damp weather. If the whoosh comes with ice that doesn’t clear, call.
Is a humming heat pump normal?
A steady, low hum while it runs is normal. A louder hum that doesn’t lead to the fan or compressor starting is not, and often means a failing capacitor or a compressor struggling to start. If it hums and doesn’t run, call, and don’t open the unit.
Why is my heat pump making a grinding noise?
Grinding usually means metal on metal, such as a worn fan motor bearing, a fan blade rubbing something or compressor wear. It tends to get worse. Stop cooling in summer or use backup heat in winter, and call for repair, since running it can damage other parts.
Why is my heat pump banging?
A bang can be a loose panel, debris or a bent fan blade, or an internal part coming loose, such as a compressor mount. A one-off bang at start-up may be ductwork or parts expanding. Repeated banging needs a technician, so note when it happens and call.
Should I turn off a noisy heat pump?
For a harsh grinding, banging or buzzing noise in summer, yes, switch cooling off and call. In winter, don’t leave the house without heat: switch the thermostat to emergency or backup heat if it has it, and call. If you smell burning or see smoke, leave and call 911.
Is a heat pump making noise at start-up or shutdown normal?
A click or soft thump at start-up or shutdown is usually relays and valves moving, and the system settling. That’s normal. A loud bang, a long buzz before starting or a squeal that lingers is not, and may point to a capacitor, contactor or bearing issue.
Can ice make my heat pump noisy?
Yes. Ice on the fan blades can scrape the guard or knock rhythmically, and a heavily iced coil makes the fan labour. Clear snow by hand or with a soft brush, never chip at ice, and call if the noise or the ice returns, since the defrost may not be working.
Who fixes a heat pump making noise in the GTA?
Assurance HVAC Heating & Cooling repairs heat pumps and mini-splits across Toronto, North York, Richmond Hill, Vaughan, Markham, Mississauga and Oakville. We find the source of the noise, you approve a flat-rate price before work starts, and repairs carry our written workmanship warranty. We’re open 24/7.
Still no heat? We’ll call you back to book a technician.
Send the form or call. You’ll get a confirmed arrival window and a price before any work starts.
Open 24/7, with technicians out day or night for no-heat and no-cooling emergencies
