
Waking up to no hot water is a bad start to any day, and in a GTA winter it can’t wait. This guide walks through the common reasons a water heater stops heating, the checks that are safe to make yourself, and the signs that mean it’s time to book water heater repair with a gas technician.
Key takeaways
- On a gas tank, a pilot that has gone out is the most common reason the water stays cold.
- On an electric tank, a tripped breaker, failed element or thermostat usually explains it.
- You can check the breaker once, the label’s relight steps and the gas control’s temperature dial.
- Never open burner or electrical compartments, or adjust a gas valve beyond the label’s steps.
- Technicians are TSSA-certified, and you approve a flat-rate price before any work starts.
Last updated . Written and reviewed by the Assurance HVAC Heating & Cooling service team.
On this page
- No hot water: three questions to answer first
- Is your water heater gas, electric or tankless?
- Gas water heater with no hot water
- Relighting a standing pilot, and when to stop
- Electric water heater with no hot water
- Tankless water heater that won’t heat
- Safe checks when you have no hot water
- Less common reasons the taps run cold
- When a water heater is too old to repair
- Gas smell, carbon monoxide and scald safety
- What a technician does on a no hot water call
- Keeping the hot water coming
- No hot water: common questions
No hot water: three questions to answer first
Before you check any equipment, narrow down the problem. Whether the cold water is at every tap or just one, whether it has been cold for a day or a week, and whether the tank is gas, electric or tankless all point to different causes, and the answers will also help a technician if you call.
- Every tap cold means the water heater itself. One tap cold usually means a faucet cartridge or mixing valve.
- Lukewarm water that runs cold quickly suggests a failed element, a sediment-filled tank or a broken dip tube.
- Water pooling around the tank means you should close the cold water valve on top, turn the gas control to off or switch off the breaker, then keep reading.
Is your water heater gas, electric or tankless?
The fuel decides which checks apply. A gas tank has a burner at the bottom, a vent pipe or flue on top and a gas control with a dial near the base. An electric tank has a wire feeding into the top or side and no vent. A tankless unit is a compact box on the wall, usually with its own vent pipes.
The rating label on the side of any of them names the fuel. If your tank is rented, check your agreement to see who handles repairs before you book anyone.
Gas water heater with no hot water
On a gas tank, the usual culprit is a burner that isn’t lighting. A standing pilot that blew out, a worn thermocouple that stops gas from reaching the burner, a failed gas control valve or blocked venting can each leave the tank cold, and the tank will cool through the day until it gives out completely.
Look at the gas control on the lower part of the tank. If the dial is on Off or Pilot, or the pilot window is dark, a relight may be all it needs. The steps below cover when that is safe and when to stop.
| What you notice | Likely cause | Who fixes it |
|---|---|---|
| Pilot window dark, tank cold | Pilot went out | You: relight once per the label |
| Pilot lights, then goes out again | Worn thermocouple or venting problem | Technician |
| Pilot stays lit, burner never fires | Gas control valve or thermostat fault | Technician |
| Burner lights, water only lukewarm | Sediment, undersized tank or broken dip tube | Technician |
| Smell of gas near the tank | Gas leak | Leave and call Enbridge Gas |
Relighting a standing pilot, and when to stop
Relighting a standing pilot is something homeowners may do, but only by following the instructions printed on the tank’s label, in order, exactly as written. Those steps are specific to your model, so don’t rely on a video or a friend’s tank. If you can’t find the label or can’t follow it, call instead.
If you smell gas at any point, stop, leave the house and call Enbridge Gas from outside. Also stop if the pilot won’t stay lit after one careful try, or if the unit has no standing pilot and lights electronically. A pilot that keeps going out means a part is failing, and our pilot light guide explains why.
Electric water heater with no hot water
An electric tank with cold water has lost power, lost an element or tripped its high-limit safety. Most electric tanks have two heating elements, and if the upper one fails, the tank gives no hot water at all, while a failed lower element leaves you with a small supply that runs out fast.
Start at the panel. Find the breaker for the water heater and see whether it’s tripped. Reset it once. If it holds, give the tank a few hours to heat. If it trips again, leave it off and call, because a breaker that keeps tripping is protecting you from a short or a failing element.
Don’t open the electrical panel or the access covers on the tank. Elements, thermostats and the reset button sit behind them, and they’re technician work.
Tankless water heater that won’t heat
A tankless unit heats water only while it’s flowing, so it can fail in ways a tank can’t. Scale on the heat exchanger, a blocked or frozen vent, low flow, a closed gas supply or a lost power connection can each stop it from firing, and many units show a code on their display.
Check that the unit has power and that other gas appliances work. In winter, brush snow and ice off the vent pipe ends outside by hand. Don’t try to decode a display code yourself. The code list is usually on a label inside the cover or in the manual, and the technician reads it on site. Our tankless descaling guide covers the most common long-term cause.
Safe checks when you have no hot water
A few checks are quick and safe, and they sort out a surprising number of cold-water mornings. Stay within this list, and stop at the first sign of gas, water on the floor or a burner that won’t light.
- Look for a tripped breaker on an electric tank and reset it once.
- On a gas tank, relight a standing pilot only by following the instructions on the tank’s label.
- On a gas tank, check that the dial on the gas control isn’t set to Off or Vacation, and turn it back only as the label describes. On an electric tank, the thermostats sit behind covers, so leave them to a technician.
- Brush snow and ice from a vent pipe end outside by hand, never with tools.
- Check whether the cold water valve on top of the tank is open, and don’t force it if it’s stiff.
- If water is leaking, close the cold water valve on top, turn the gas control to off or switch off the breaker, and call.
Less common reasons the taps run cold
If the heater is working but the taps aren’t, the problem sits downstream. A mixing valve or faucet cartridge that has failed can leave one fixture cold. Cross-connected plumbing, a bad mixing valve on a single-lever shower or a recent plumbing job can also send hot water elsewhere.
Tank-side faults exist too: a gas control valve that has stopped opening, a high-limit switch that has tripped, a failed thermostat or a water heater that is simply too old. Those need testing with the right tools, so they belong to a technician.
When a water heater is too old to repair
A tank water heater typically lasts 8 to 12 years. Past that, a repair may work, but another failure is likelier, and a tank that is rusty or leaking at the body can’t be repaired at all. Tankless units last longer, about 20 years, though they need regular descaling.
If your tank is near the end of its life, ask for a flat-rate quote on a replacement alongside the repair, so you can compare. Our water heater installation page explains how tanks and tankless units are sized and installed.
Gas smell, carbon monoxide and scald safety
A gas water heater burns fuel inside your home, so safety comes before the hot water. If you smell gas, leave the house right away without switching anything on or off and without using a phone inside. From outside, call Enbridge Gas at 1-866-763-5427.
- If a carbon monoxide alarm sounds, everyone leaves the house, pets too, and you dial 911 from outside.
- In Ontario, homes with a fuel-burning appliance, a fireplace or an attached garage need working CO alarms next to sleeping areas and on every storey.
- Hot water at the tap is commonly set around 49°C to limit scalds, so take care if the setting has been turned up.
Alarm rules are set out on the province’s carbon monoxide safety (opens in a new tab) page.
What a technician does on a no hot water call
A TSSA-certified gas technician starts by finding out which part of the system has failed. On a gas tank, that means checking the pilot, thermocouple or ignitor, the gas control valve, the venting and the flue. On an electric tank, the technician tests the elements, thermostats and the high-limit switch.
The price is flat-rate and approved by you first, and repairs carry our written workmanship warranty. We’re open 24/7, so you can call about a cold tank at any hour.
Keeping the hot water coming
Most cold-water mornings give some warning: water that runs lukewarm sooner than it used to, a pilot that needs relighting, or a tank that rumbles. A yearly check and an occasional flush help the tank last, and our maintenance plan covers two tune-ups a year, the furnace each fall and the air conditioner each spring.
No hot water: common questions
Why is there no hot water in my house all of a sudden?
Sudden loss of hot water usually means the heater stopped heating. A gas tank’s pilot may have gone out, an electric tank may have tripped its breaker or lost an element, and a tankless unit may have a blocked vent or no power. Check the breaker once and the pilot label, then call if it doesn’t recover.
How long does a tank take to heat water again?
It depends on the tank size and fuel. A gas tank recovers faster than an electric one, and a larger tank takes longer to warm from fully cold. As a rule, give a restarted tank a few hours before judging it. If the water is still cold the next morning, something else is wrong.
Can a tripped breaker cause no hot water?
Yes, on an electric tank. Find the water heater’s breaker, switch it fully off and back on once. If the water heats, you’re done. If the breaker trips again, leave it off and call, because repeated trips point to a failing element or wiring fault that shouldn’t be reset again and again.
Is it safe to relight my water heater’s pilot light?
It’s safe to relight a standing pilot only by following the instructions printed on the tank’s label, step by step. If you smell gas, leave the house and call Enbridge Gas at 1-866-763-5427 from outside. If you can’t find the label or the pilot won’t stay lit, stop and call us. Never adjust a gas valve beyond what the label describes.
Why do I have hot water in the kitchen but not the shower?
If the heater is fine, the problem is local to that fixture. A failed mixing valve or cartridge in the shower is the usual cause, and a plumbing change that has crossed the hot and cold lines is another. Every tap running cold points back to the water heater.
Does a tankless water heater run out of hot water?
A tankless unit doesn’t store hot water, so it doesn’t run out in the same way. But it has a limit on how many fixtures it can serve at once, and scale, low flow or a blocked vent can stop it heating. Cold water on a tankless system is worth a service call.
Should I repair or replace a water heater with no hot water?
Age and the failed part decide it. A newer tank with a cheap part is worth repairing. A tank over 10 years old, or one leaking from the body, is usually better replaced. We give a flat-rate price before work starts, so you can compare the options with real numbers.
Who can fix no hot water in the GTA?
Our TSSA-certified gas technicians repair gas, electric and tankless water heaters throughout the GTA, from Toronto and North York out to Oakville. We work on all major brands, and you approve a flat-rate price before any work begins. Calls are answered 24/7.
Still no hot water? We’ll call you back to book a technician.
Send the form or call. You’ll get a confirmed arrival window and a price before any work starts.
Open 24/7, with technicians out day or night for no-heat and no-cooling emergencies
