
The tank vs tankless water heater question comes down to how your household uses hot water, how much space you have and what your home can support. Both work well, and neither is right for everyone. This guide compares them fairly, explains what changes when you switch, and points to water heater installation for a sized, flat-rate quote.
Key takeaways
- A tank stores hot water. A tankless unit heats water on demand as it flows.
- Tankless units usually last longer, about 20 years against 8 to 12 for a tank.
- Switching to tankless often needs a bigger gas line, new venting or more electrical capacity.
- Flow rate limits how many fixtures a tankless unit can run at once.
- We size either type to your home and give a flat-rate price before work starts.
Last updated . Written and reviewed by the Assurance HVAC Heating & Cooling service team.
On this page
- Tank vs tankless water heater: how each one works
- Tank vs tankless water heater at a glance
- Hot water supply: stored volume against flow rate
- Space, lifespan and running costs
- What changes when you switch from a tank to tankless
- Condensing units, recirculation and other options
- Maintenance: flushing against descaling
- Tank vs tankless water heater: which suits your home?
- Gas, carbon monoxide and scald safety
- How we size and install either type
- Tank vs tankless water heater: repair, replace or switch
- Tank vs tankless water heater: common questions
Tank vs tankless water heater: how each one works
A tank water heater keeps a set volume of water hot all day, and draws on that supply until it runs low. A tankless unit keeps no stored water. It fires a burner or electric elements only when a tap opens, heating the water as it passes through a heat exchanger.
That single difference drives nearly everything else: how much hot water you get at once, how much space it takes, how it’s installed and how long it lasts.
Tank vs tankless water heater at a glance
The table below compares the two across the points most homeowners ask about. It uses typical industry figures, and your own results depend on the model, the water and how the home is used.
| Point | Tank | Tankless |
|---|---|---|
| Hot water supply | Limited by tank size, then a recovery wait | Continuous, limited by flow rate |
| Space | Large floor footprint | Compact, wall mounted |
| Typical lifespan | 8 to 12 years | About 20 years |
| Upfront cost | Lower equipment cost | Higher equipment cost, often more installation work |
| Running cost | Heat is lost from the stored water | No standby loss, but it varies with use |
| Maintenance | Flush; technician checks the anode rod | Descale, often yearly in hard water |
| Installation changes | Usually a straight swap | Often gas line, venting or electrical upgrades |
Hot water supply: stored volume against flow rate
A tank can supply several fixtures at once until it runs out, then you wait for it to recover. A tankless unit never runs out, but it can only heat so much water per minute, so too many fixtures at once can drop the temperature or the flow.
That is why sizing matters most with tankless. In winter, the water entering the house is colder in Ontario, so the unit has to raise it further, and the flow it can handle drops. A unit sized for a long shower and a dishwasher in July may struggle in January.
Space, lifespan and running costs
A tankless unit frees up floor space, and the longer lifespan, about 20 years against 8 to 12, spreads its higher equipment cost over more years. A tank loses a little heat all day from the stored water, while a tankless unit doesn’t, which can mean lower running costs for homes that use modest amounts of hot water.
Households that use a lot of hot water at once may see smaller savings, so treat any promise of fixed savings with care. ENERGY STAR Canada lists qualifying models (opens in a new tab) for those comparing efficiency.
What changes when you switch from a tank to tankless
A tank swap is usually like for like. Going tankless is a bigger job, because a tankless unit demands more fuel or power in a short burst than a tank does. Each item below can add work and cost, so it’s worth checking before you commit.
- Gas: a larger gas line or meter capacity may be needed to feed the burner.
- Venting: tankless units vent through sealed plastic or stainless pipe, often out a side wall.
- Electric: an electric tankless unit often needs a large amount of electrical capacity and a heavier circuit.
- Plumbing: valves for servicing, and sometimes a condensate drain on condensing models.
- Water: hard water means regular descaling to keep the heat exchanger working.
Condensing units, recirculation and other options
Condensing tankless units capture extra heat from the exhaust, so they run more efficiently, but they produce condensate that has to drain. Some units add a recirculation loop or a small buffer tank to cut the wait for hot water at distant taps.
Where a home already has a hydronic boiler, a combi boiler can heat water as well as the house. That’s a different system, with its own pros and cons.
Maintenance: flushing against descaling
A tank needs the occasional flush and a technician’s check of the anode rod, and a flush is a job homeowners may do with care. Our how to flush a water heater guide explains it. A tankless unit needs descaling, where a solution is circulated through the heat exchanger.
Skipping descaling in hard water can cut performance and shorten life. Our tankless descaling guide explains how often and why.
Tank vs tankless water heater: which suits your home?
A tank suits homes that want the simplest, lowest-cost swap and a steady household pattern. A tankless unit suits homes that want to save space, expect to stay long enough to benefit from the longer life, and can support the extra gas, venting or electrical work.
- Pick a tank for a straightforward swap, a lower equipment cost or a home where upgrades are hard.
- Pick tankless for space, a long stay in the home and a household with steady, moderate demand.
- Think twice about tankless where many fixtures run at once and the gas line or electrical supply is limited.
- Ask for both options priced, so you can compare them with real numbers.
Gas, carbon monoxide and scald safety
Both types burn fuel inside the home if they’re gas, so safety matters. On a gas model, a gas smell is a reason to get everyone out, skip the switches and indoor phones, and call Enbridge Gas at 1-866-763-5427.
- If a CO alarm sounds near a gas unit, the whole household goes outside with the pets and someone calls 911.
- Ontario requires CO alarms next to each sleeping area and on every storey of any home with a fuel-burning appliance, a fireplace or an attached garage, so a gas unit brings that requirement.
- Water heaters are often set near 49°C at the tap to limit scalds, so take care around hot water and the relief valve pipe.
Ontario’s carbon monoxide safety (opens in a new tab) page is worth a read if you’re comparing gas units.
How we size and install either type
A TSSA-certified gas technician sizes the unit to your household and fixtures, checks the gas line, venting and drains, and installs it to code with proper venting and expansion protection. For a tank, sizing is by volume and recovery. For tankless, it’s by flow and temperature rise.
Installation is quoted at a flat-rate price you approve up front and is backed by our written workmanship warranty. Our tankless water heaters page covers how those installs work.
Tank vs tankless water heater: repair, replace or switch
If your tank is near the end of its life, the decision is the same one again: repair it, replace it like for like, or switch. Our how long do water heaters last guide helps judge age, and water heater repair is the place to start if it can still be saved.
Tank vs tankless water heater: common questions
Is a tankless water heater better than a tank?
Neither is better for everyone. Tankless gives continuous hot water, saves space and lasts longer, but it costs more up front and may need gas, venting or electrical upgrades. A tank is simpler and cheaper to swap. The right choice depends on your household and what your home can support.
Will a tankless water heater save me money?
It can lower running costs because it doesn’t keep water hot all day, but savings vary with how much hot water you use and the price of fuel. The higher equipment and installation cost also matters. Ask for both options priced and compare over the life of each.
How long does each type last?
A tank water heater typically lasts 8 to 12 years. A tankless unit commonly lasts about 20 years with regular descaling. Hard water, maintenance and the unit itself all affect that, so treat the figures as general guidance rather than a promise.
Can a tankless unit run two showers at once?
Often, if it’s sized for it. Each fixture draws flow, and the unit has a limit on how much water it can heat at once. In winter, colder incoming water lowers that limit. We size by flow and temperature rise so the unit matches how your household uses water.
Does switching to tankless need new gas or venting?
Often, yes. A tankless unit burns fuel faster than a tank, so the gas line may need to be larger, and it vents through its own sealed pipes. An electric tankless unit often needs a large amount of electrical capacity. A technician checks all of this before quoting.
Does a tankless water heater need maintenance?
Yes. Hard water leaves scale in the heat exchanger, so a tankless unit needs descaling, often yearly in the GTA. A tank needs an occasional flush and a technician’s check of the anode rod. Regular care helps both types last longer.
Can I switch from a tank to tankless in an older home?
Usually, but older homes can need more work, such as a bigger gas line, a new vent route or an electrical upgrade. A technician looks at the existing gas, venting and plumbing and tells you what’s needed before you approve any work.
Who installs tank and tankless water heaters in the GTA?
We install both types for homes in North York, Toronto, Vaughan, Richmond Hill, Markham, Oakville and Mississauga, using TSSA-certified gas technicians. Every major brand is covered, the phones are answered 24/7, and the flat-rate price is yours to approve before any installation begins.
Planning a replacement? We’ll call you back to book a quote visit.
Send the form or call. You’ll get a confirmed arrival window and a price before any work starts.
Open 24/7, with technicians out day or night for no-heat and no-cooling emergencies
