Skip to content
Water heater tank in an unfinished basement
Assurance HVAC Heating & Cooling of Markham

Water heater repair in Markham

(647) 496-5598Open 24/7, day or night

Assurance HVAC Heating & Cooling of Markham provides water heater repair in Markham for gas, power vent and electric tanks, and for tankless units too. Our TSSA-certified gas technicians find the failed part, explain what it costs to fix and tell you honestly when a tank is finished. If it has reached that point, see water heater installation in Markham.

Request a technician

Tell us what’s going on. We’ll call to confirm a time.

What do you need?
How soon? Optional
Add email, details or text updatesOptional

Or call (647) 496-5598Used only to book your visit. Privacy

Key takeaways

  • Repairs for no hot water, leaks, pilot problems, noise and rusty water across Markham.
  • Gas work done by TSSA-certified gas technicians, WSIB covered and fully insured.
  • A flat-rate price you approve before work starts, and a written workmanship warranty.
  • Honest advice on repair or replacement, with both prices shown for older tanks.
  • No-hot-water calls answered 24/7, with technicians out day or night.

Last updated . Written and reviewed by the Assurance HVAC Heating & Cooling of Markham service team.

On this page
  1. Water heater repair in Markham: signs to act on
  2. Checks that are safe for any homeowner
  3. Short on hot water, or scalding at the tap
  4. Rusty, smelly water and the anode rod
  5. Rumbling, popping and sediment
  6. Common water heater repair in Markham: gas controls, igniters and elements
  7. Power vent heaters in newer Markham homes
  8. Older chimneys and tanks in Unionville and Markham Village
  9. A leaking tank: what can and can’t be repaired
  10. Tankless units: descaling, flame failure and venting
  11. Water heater repair in Markham or a new tank: a decision guide
  12. When to shut things off, and when to leave the house
  13. What a repair visit looks like, day or night
  14. What changes the price of a Markham water heater repair
  15. Water heater repair questions from Markham homeowners

Water heater repair in Markham: signs to act on

A Markham water heater usually gives warning before it fails, and the symptom points to the cause: no hot water, too little of it, water that is too hot, odd noises, rusty or smelly water, or moisture around the base. Acting early often keeps a small repair from becoming a flood.

  • No hot water at all, or only lukewarm water
  • Hot water that runs out much sooner than it used to
  • Water that is scalding at the tap
  • Rumbling, popping or hissing from the tank
  • Rusty, cloudy or smelly hot water
  • A pilot or burner that won’t stay lit
  • Dampness, drips or a puddle around the base

Checks that are safe for any homeowner

Four checks are safe for any Markham homeowner and sometimes bring the hot water back. Each takes a minute and needs no tools. If you smell gas at any point, stop and follow the safety steps further down this page.

  • Gas tank: confirm the gas supply valve is open, and follow the lighting instructions on the label on the tank if the pilot is out.
  • Electric tank: check the breaker for the water heater at the panel.
  • Power vent: make sure the unit is plugged in and that its vent pipe outside isn’t blocked by snow.
  • Water: if there is a leak, close the cold water valve on top of the tank.

If the pilot goes out again after relighting, don’t keep trying. That is a sign of a failing part, and a technician should look at it.

Short on hot water, or scalding at the tap

When a tank runs out too quickly, the cause is usually inside it: a broken dip tube mixing cold water into the hot, a failed electric element, a faulty thermostat or a build-up of sediment that takes up space. A thermostat set too high or failing causes the opposite problem.

Markham water heaters are commonly set around 49°C at the tap to reduce the risk of scalds, especially in homes with children or older adults. If the water is hotter than the setting, a faulty thermostat or gas control may be to blame, and it’s worth having it checked.

Rusty, smelly water and the anode rod

Rusty or smelly hot water in a Markham home often points to the anode rod, a sacrificial metal rod inside the tank that corrodes so the tank doesn’t. When it is used up, the tank itself starts to corrode, and bacteria can produce a rotten-egg smell.

Replacing a worn anode rod early can extend a tank’s life, and flushing out sediment helps too. If the tank has already rusted through, no part will fix it. We check the water at the tap and at the tank, so we can tell you whether it is the rod, the water supply or the tank.

Rumbling, popping and sediment

A rumbling or popping tank in Markham is almost always full of sediment. Minerals in the water settle at the bottom, and as the burner or element heats the water under that layer, steam bubbles force their way up through it and make the noise.

Sediment also makes a heater less efficient and can overheat the bottom of a steel tank. A flush can clear it if caught early. Hard water is common in the GTA, so sediment is a frequent finding. If the tank is old and heavily scaled, we explain whether a flush is worth doing or whether it would just expose a leak.

Common water heater repair in Markham: gas controls, igniters and elements

Most water heater repair in Markham involves a short list of parts, and which one depends on the type of heater. Our technicians test each before replacing it, and gas parts are only ever handled by TSSA-certified gas technicians.

Symptoms and the parts we usually test
Type of heaterSymptomParts we usually test
Gas tank, standing pilotPilot won’t stay litThermocouple, pilot assembly, gas control valve
Gas tank, electronic ignitionNo flame or lockoutIgniter, flame sensor, control board
Power ventNoisy, or won’t startBlower, pressure switch, vent pipe
Electric tankLukewarm or no hot waterUpper and lower elements, thermostats, high-limit reset
Any tankDripping from a valveTemperature and pressure relief valve, expansion pressure
Any tankMixed or short hot waterDip tube, anode rod, sediment

Power vent heaters in newer Markham homes

In newer Markham homes, from Berczy Village and Wismer to Cachet and Cathedraltown, the water heater may be a power vent model, which uses a fan to push exhaust out through plastic pipe. They have more parts than a natural-draft tank, and a fan noise or a lockout is usually a sign that one of them is struggling.

The blower, the pressure switch and the vent pipe are the first things we test. Snow or ice at the outside terminal or a failing blower motor are common causes. We also check the combustion air and the gas supply, since a safe, steady flame depends on all of them.

Older chimneys and tanks in Unionville and Markham Village

Older and heritage homes in Unionville and Markham Village are more likely to have a water heater venting into an old masonry chimney, sometimes one it now shares with nothing else. Chimney venting has its own faults: a draft that is too weak, a blockage or a deteriorating flue.

When we repair a heater like this in Markham, we check that the exhaust leaves the house properly, because spillage can bring carbon monoxide inside. Ontario’s rules call for a carbon monoxide alarm beside every sleeping area, plus one on every storey since January 1, 2026, in homes with a fuel-burning appliance, a fireplace or an attached garage, and we recommend testing them each season. See the province’s carbon monoxide safety page (opens in a new tab).

A leaking tank: what can and can’t be repaired

A leak from a fitting, valve or connection in a Markham home can usually be repaired, but a leak from the body of the tank can’t. Once the steel shell has corroded through, the tank needs replacing, and a patch is not a safe or lasting fix.

Close the cold water valve on top of the tank to stop the supply, and switch off the gas or the breaker. We find where the water is really coming from, because condensation, a loose connection or a dripping relief valve can look like a failed tank. If it is the tank, you can compare options on our page about tankless water heaters in Markham as well as a new tank.

Tankless units: descaling, flame failure and venting

Tankless water heaters have their own short list of problems: scale in the heat exchanger, flame failures, venting faults and error codes. Hard water is common in the GTA, so descaling is often the first thing a tankless unit needs.

Our technicians flush the unit with a descaling solution, test the flame sensor and gas flow, check the vent and inspect the inlet filter. A tankless unit that has gone unserviced for years may need more than a flush, and we tell you plainly if so.

Water heater repair in Markham or a new tank: a decision guide

A tank water heater in Markham lasts about 8 to 12 years, so age is the biggest factor in the decision. A young tank with a failed part is almost always worth repairing. An old one with a leak, or one repairs keep chasing, usually isn’t.

Repair or replace a tank water heater
Looking atRepair often winsReplacement often wins
AgeUnder about 8 years8 to 12 years or older
Failed partThermocouple, igniter, element, thermostat, valveA leak from the tank body
Water qualityClear water, a good anode rodRust, heavy sediment or scale
Repair historyFirst call in yearsRepeated repairs
Household needsHot water is still enoughYou have outgrown the tank

If replacement is the better value, we show both prices side by side. We also explain the option of renting versus owning, so you can choose for yourself.

When to shut things off, and when to leave the house

Some water heater problems in Markham homes are urgent. A gas smell means leaving the house straight away, a relief valve that discharges steadily means turning the heater off and calling, and a tank that is leaking heavily needs its water supply closed.

  • Gas smell: leave the house without using switches, matches or your phone inside. From outside, call Enbridge Gas at 1-866-763-5427.
  • Carbon monoxide alarm sounding: get everyone outside and call 911.
  • Relief valve discharging steadily: turn the heater off and call us.
  • Heavy leak: close the cold water valve on top of the tank and switch off the gas or power.

Enbridge Gas has more on gas safety at its safety page (opens in a new tab). Once it is safe, we repair the heater. To book, use our contact page or call the number on this page. Our HVAC contractor in Markham page lists the rest of what we do.

What a repair visit looks like, day or night

A water heater repair visit in Markham gives you a diagnosis, a flat-rate price and your approval before anything is replaced. Booked visits get a two-hour arrival window and a text when we set off. No-hot-water calls are answered 24/7, and technicians go out day or night.

Our Markham technician checks the gas or power supply, the controls, the venting and the tank, then explains what failed and why. If the fix is quick, it is often done on the same visit. If a part has to be ordered, you hear the timing first, and the price you approved stays the same.

What changes the price of a Markham water heater repair

The cost of water heater repair in Markham depends on the part that failed, the type of heater and how easy it is to reach. You get a flat-rate price before work starts, so you never pay for a guess.

What changes the price of a water heater repair
FactorWhat it changes
Part that failedA thermocouple or an element is quick. A gas control valve, blower or tankless heat exchanger takes more time and costs more.
Type of heaterPower vent and tankless units have more parts and controls than a standard tank.
Age and modelOlder or less common models can need parts ordered in.
Water qualityHeavy scale or sediment can add flushing or descaling time.
AccessA crowded utility room, a finished ceiling or a closet takes longer.
FAQ

Water heater repair questions from Markham homeowners

Why is there no hot water in my Markham house?

On a gas tank, the pilot may be out or the thermocouple or igniter may have failed. On an electric tank, a tripped breaker or a failed element or thermostat is likely. On a power vent, the fan or a blocked vent can stop it. Check the supply first, then call us for a diagnosis.

What is that rumbling inside my water heater?

It is nearly always sediment. Minerals settle at the bottom of the tank and steam bubbles pass through the layer, making a rumbling or popping sound. A flush can help if caught early. If the tank is old and heavily scaled, we explain whether flushing is worth doing or whether replacement makes more sense.

Do you offer water heater repair in Cornell or Box Grove?

Yes. Water heater repair in Markham covers every neighbourhood, including Cornell, Box Grove, Wismer, Greensborough, Buttonville and Milliken. Call or send the request form, and a real person calls you back. No-hot-water calls are answered 24/7, and booked visits get a two-hour arrival window.

Is a leaking water heater always finished?

It depends on where the water comes from. A leak at a fitting, valve or connection can usually be fixed. A leak from the body of the tank means the steel has corroded through, and the tank needs replacing. Close the cold water valve on top of the tank, switch off the gas or power, and call us.

What makes a pilot light go out again and again?

A pilot that won’t stay lit usually points to a worn thermocouple, a dirty pilot assembly or a faulty gas control valve. A draft or a blocked vent can also blow it out. Relight it once following the label, and if it goes out again, stop and call a technician rather than trying repeatedly.

What setting is safest on the water heater dial?

Water heaters are commonly set around 49°C at the tap, which reduces the risk of scalds, particularly for children and older adults. A higher setting gives hotter water but a higher scald risk. If the water seems hotter than the setting, a faulty thermostat may be the cause, so it’s worth a check.

Is it worth replacing the anode rod?

Often, yes, if the tank is still fairly young and sound. The rod corrodes in place of the tank, so replacing a worn one can add years of life, and changing the rod type can help with a rotten-egg smell. If the tank is already rusting inside or leaking, a new rod won’t help, and we will tell you so.

Can you repair a tankless water heater from any brand?

We service all major brands. The most common tankless repairs are descaling the heat exchanger, cleaning the inlet filter, replacing the flame sensor and fixing venting problems. If a unit has been left without service for years, it may need more than a flush, and we explain that before any work.

Book a visit

Need water heater repair in Markham? We’ll call you back to book.

Send the form or call. You’ll get a confirmed arrival window and a price before any work starts.

(647) 496-5598

Open 24/7, with technicians out day or night for no-heat and no-cooling emergencies

Request a technician

Tell us what’s going on. We’ll call to confirm a time.

What do you need?
How soon? Optional
Add an email or detailsOptional

Or call (647) 496-5598Used only to book your visit. Privacy