Skip to content
Technician servicing a wall-mounted boiler
Assurance HVAC Heating & Cooling of Markham

Boiler installation in Markham

(647) 496-5598Open 24/7, day or night

Assurance HVAC Heating & Cooling of Markham handles boiler installation in Markham for older radiator homes in Unionville, compact condos in Cornell and larger houses with heated floors. Our TSSA-certified gas technicians size the new boiler to your home’s heat loss, plan the venting and piping, and give you a flat-rate price first. If yours still runs but has started to fail, see boiler repair in Markham.

Get an installation quote

Tell us about your home. We’ll call to book a quote visit.

What do you need?
How soon? Optional
Add email, details or text updatesOptional

Or call (647) 496-5598Used only to book your visit. Privacy

Key takeaways

  • Condensing and combi boiler installation for radiators and radiant floors across Markham.
  • Sized to the home’s heat loss and radiators, not to the old boiler’s rating.
  • Gas work done by TSSA-certified gas technicians, WSIB covered and fully insured.
  • One flat-rate price approved before work starts, and a written workmanship warranty.
  • No-heat emergencies are answered 24/7; booked visits get a two-hour arrival window.

Last updated . Written and reviewed by the Assurance HVAC Heating & Cooling of Markham service team.

On this page
  1. Signs it is time for boiler installation in Markham
  2. Which Markham homes have boilers
  3. Condensing boilers: what 90% AFUE asks of the system
  4. Boiler installation in Markham’s heritage homes: venting off the chimney
  5. Combi boiler or heat-only boiler with a tank
  6. Sizing from heat loss and radiators, not the old boiler’s rating
  7. Cast iron radiators keep working with a new boiler
  8. Near-boiler piping and the parts around the boiler
  9. In-floor radiant heat in larger newer homes
  10. Compact combi installs in Cornell and Markham Centre
  11. What boiler installation in Markham looks like on the day
  12. Planning a boiler replacement before the cold arrives
  13. Pricing boiler installation in Markham: what moves the number
  14. Boiler installation questions from Markham homeowners

Signs it is time for boiler installation in Markham

A boiler is ready for replacement when repairs keep coming, parts can no longer be found, or the heat exchanger leaks. Age and efficiency matter too, but a single serious failure is often what settles it.

  • Water leaking from inside the boiler jacket or the heat exchanger
  • Repeated lockouts that a reset only fixes for a few days
  • Parts that are discontinued or have to be ordered in each time
  • Rust, mineral scale or sludge in the system water
  • Rising gas bills for the same level of comfort
  • A boiler that is noisy, with banging or kettling that cleaning doesn’t cure

Which Markham homes have boilers

Boilers are the exception in Markham, not the rule, because most Markham homes were built with forced-air furnaces. They turn up in some older Unionville houses with cast iron radiators, in some larger newer homes with in-floor radiant heat, and in condos and townhomes with compact combi boilers.

That mix means a Markham installation is rarely a copy of the last job. We start by learning what the house has: radiators, radiant loops or both, whether the boiler also makes hot water and where the chimney or vent runs.

Condensing boilers: what 90% AFUE asks of the system

A condensing boiler reaches 90% AFUE or more by cooling its exhaust until the water vapour turns to liquid, which captures heat a conventional boiler sends up the chimney. The catch is that it only condenses when the water returning to it is cool enough.

That puts demands on the system around it: lower return temperatures, sensible controls, a drain for the acidic condensate and plastic venting. Done properly, the boiler runs at a lower temperature on mild days and saves gas. Done carelessly, it never condenses and performs like an older unit.

Boiler installation in Markham’s heritage homes: venting off the chimney

A condensing boiler doesn’t use the old chimney. It vents through plastic or polypropylene pipe, as the maker specifies, usually out a side wall, and that changes the work in an older home with a masonry chimney.

Once the boiler leaves the chimney, anything else still using it, such as a gas water heater, may need a liner or its own new vent. We check the whole chimney before quoting. Unionville and Markham Village include heritage conservation districts, where changes visible from the street can need approval, so ask the City of Markham (opens in a new tab) what applies before a vent terminal goes on a front wall.

Combi boiler or heat-only boiler with a tank

A combi boiler heats the home and makes hot water on demand in one unit, while a heat-only boiler heats the home and relies on a separate indirect water heater tank for hot water. The right choice depends on space, household size and how much hot water you use at once.

Combi boiler or heat-only boiler with an indirect tank
Combi boilerHeat-only boiler with indirect tank
Hot waterOn demand, limited by flow at the tapStored, ready for several fixtures at once
SpaceOne compact unit, good for closetsBoiler plus a tank, needs more room
Best forSmaller homes, condos and townhomesLarger households with several bathrooms
Heat and hot waterShare one burner and heat exchangerRun as two loops from one boiler

Our HVAC contractor in Markham page lists the rest of what we do, and our page on water heater installation in Markham covers the tank side of this choice.

Sizing from heat loss and radiators, not the old boiler’s rating

A new boiler is sized from a room-by-room heat-loss calculation and the output of the radiators or floor loops, not from the old boiler’s label. Many older boilers were oversized, and an oversized condensing boiler short cycles, wears faster and loses efficiency.

We measure the radiators in your Markham home, count the windows and note any renovations or additions since the last boiler went in. The result sets the boiler’s output and tells us whether the existing radiators can heat the house at lower water temperatures. Sometimes a radiator in a cold corner needs replacing or enlarging.

Cast iron radiators keep working with a new boiler

Cast iron radiators are not a reason to avoid a condensing boiler. They hold a lot of water and give off heat for a long time, so they work well at the lower temperatures a condensing boiler prefers, though they respond more slowly.

An outdoor reset control adjusts the water temperature to match the weather, so the boiler runs cooler on mild days and condenses more of the time. We bleed the radiators, check the valves and flush the system, so the new boiler isn’t working into old sludge.

Near-boiler piping and the parts around the boiler

The piping around a Markham boiler is as important as the boiler itself. Pumps, an air separator, an expansion tank, a pressure relief valve and isolation valves all determine how well the system moves heat and how long it lasts.

Depending on the home, we may use primary and secondary loops, so the boiler and the radiators each get the flow they need, or separate zones for floors, radiators and a hot water tank. Good piping also makes later service easier, which matters in a tight mechanical room.

In-floor radiant heat in larger newer homes

Some of the larger newer homes in Markham have in-floor radiant heat in a basement, bathroom or addition. These loops run at low temperatures, which suits a condensing boiler well.

If radiators and floors share a boiler, we add mixing controls so the floors get the cooler water they need. Each zone has its own thermostat, and we check the existing manifold and loops before the boiler is chosen. A heated floor system that has been neglected may need flushing before a new boiler is connected.

Compact combi installs in Cornell and Markham Centre

Townhomes and condos in Cornell and Markham Centre have compact mechanical closets, and some hold a combi boiler, so installation there is about fit, access and venting. A combi boiler is a natural choice because it replaces two appliances with one.

We check the closet’s clearances, the vent route to an exterior wall, the condensate drain and the gas supply. For condos, we also check your building’s rules about who may work on in-suite equipment and about changes to exterior walls, which can limit where a vent terminal goes.

What boiler installation in Markham looks like on the day

A Markham boiler replacement is a bigger job than a furnace swap, because it involves water, gas, venting and controls. Before we start, you get the plan and a realistic schedule, and you get a two-hour arrival window and a text when the crew sets off.

  • The old boiler is drained, disconnected and removed.
  • New vent, condensate drain and neutralizer, gas connection and piping are installed.
  • The system is flushed and filled, and air is purged from the loops.
  • Controls, outdoor reset and zones are set, and the boiler is commissioned and tested.
  • We walk through the thermostat, the pressure gauge and what to do if something looks wrong.

We handle the permits and inspections the job needs. Our maintenance plan books a yearly boiler visit after installation. Gas work is done by TSSA-certified gas technicians; the TSSA (opens in a new tab) is the regulator for gas safety in Ontario. Since January 1, 2026, Ontario has required carbon monoxide alarms on every storey, as well as next to each sleeping area, in homes with a fireplace, an attached garage or any fuel-burning appliance. If you smell gas, leave the house and call Enbridge Gas at 1-866-763-5427 from outside. If a carbon monoxide alarm sounds, get everyone outside and call 911.

Planning a boiler replacement before the cold arrives

A planned Markham boiler replacement in summer or early fall is calmer to schedule than an emergency one in January. You have time to compare options, order the right unit and have the system running before the first cold night.

If the boiler fails in a Markham winter, call us. Our line is open 24/7, and no-heat calls go to the front of the line. We explain the options and the flat-rate price before anything is done.

Pricing boiler installation in Markham: what moves the number

The cost of a new boiler in Markham depends on the type, size and efficiency, plus everything needed around it. You get a flat-rate price before work starts, based on what we see in your home, and it doesn’t change halfway through.

What changes the price of a boiler installation
FactorHow it affects the job
TypeA combi boiler, a heat-only boiler with a tank and a boiler with radiant floors are different jobs.
Size and efficiencySet by the heat-loss calculation. Higher efficiency and modulating burners cost more up front.
VentingMoving off a chimney, a long vent run or a liner for another appliance adds work.
Piping and controlsPrimary and secondary loops, zones, mixing and outdoor reset add parts and labour.
Condition of the systemSludge, failed valves or leaking radiators may need work first.
AccessTight closets and basements take longer.
FAQ

Boiler installation questions from Markham homeowners

Can a condensing boiler work with my old cast iron radiators?

Yes. Cast iron radiators suit lower water temperatures, which is where a condensing boiler works best. We check each radiator’s output against your home’s heat loss, flush the system and add an outdoor reset control, so the boiler condenses most of the time. A cold corner may need a larger radiator.

Should I choose a combi boiler or a boiler with a separate tank?

It depends on the household. A combi suits smaller homes, condos and townhomes where space is tight and fewer fixtures run at once. A heat-only boiler with an indirect tank suits larger families with several bathrooms. We look at your usage and space, then show both options.

Do you offer boiler installation in Unionville?

Yes. Boiler installation in Markham covers Unionville, Markham Village, Cornell, Angus Glen, Cathedraltown and every other neighbourhood. Call or send the request form, and a real person calls you back to book a visit, measure the radiators and give you a flat-rate price.

Will the new boiler use the old chimney?

Usually not. A condensing boiler vents through plastic or polypropylene pipe, typically out a side wall, as the maker specifies. If a gas water heater still uses the chimney, it may need a liner or its own vent. We check the whole system before we quote, so nothing is a surprise.

Does a boiler replacement need permits?

Gas and heating work usually involves permits and inspections, and we handle the ones the job needs. Gas work is done by TSSA-certified gas technicians. Ask us before you book if you have questions about a heritage district or a condo, since those can add rules about venting and exterior changes.

How is a new boiler sized?

From a room-by-room heat-loss calculation, plus the output of your radiators or floor loops. We don’t copy the old boiler’s rating, because many older boilers were oversized. A boiler that’s too large short cycles, wastes gas and wears faster, while one that’s too small can’t keep the house warm.

What is an outdoor reset control?

It’s a sensor that tells the boiler how cold it is outside and lowers the water temperature on mild days. The boiler runs cooler, and a condensing boiler spends more time in its efficient range. It also gives steadier room temperatures. We often add one to a new installation for that reason.

Can I keep my in-floor heating when I replace the boiler?

Yes. Radiant floor loops stay in place, and we connect the new boiler to them. Because floors need cooler water than radiators, a home with both gets mixing controls and separate zones. We check the manifold and the loops first, and flush the system if it has been neglected.

Book a visit

Need boiler installation in Markham? We’ll call you back to book.

Send the form or call. You’ll get a confirmed arrival window and a price before any work starts.

(647) 496-5598

Open 24/7, with technicians out day or night for no-heat and no-cooling emergencies

Get an installation quote

Tell us about your home. We’ll call to book a quote visit.

What do you need?
How soon? Optional
Add an email or detailsOptional

Or call (647) 496-5598Used only to book your visit. Privacy