Skip to content
Water heater tank in an unfinished basement
Assurance HVAC Heating & Cooling of Mississauga

Water heater installation in Mississauga

(647) 492-6590Open 24/7, day or night

Assurance HVAC Heating & Cooling of Mississauga offers water heater installation in Mississauga for houses of every era, from 1960s side-splits in Erin Mills and Applewood to Churchill Meadows townhomes and new builds by the lake. We install gas and electric tanks, power-vented models and tankless units, repair heaters that are still sound, and price each job at one flat rate before work begins. Our HVAC contractor in Mississauga page covers the furnaces, air conditioners and heat pumps we look after.

Request a technician

Tell us what’s going on. We’ll call to confirm a time.

What do you need?
How soon? Optional
Add email, details or text updatesOptional

Or call (647) 492-6590Used only to book your visit. Privacy

Key takeaways

  • Tank, tankless and power-vented water heaters installed and repaired across Mississauga.
  • Venting, gas supply and space checked before we quote, in every type of home.
  • TSSA-certified gas technicians connect the gas and test the draft.
  • You approve one flat-rate price first, and the work carries a written warranty.
  • We remove and recycle the old tank, often on the day you call.

Last updated . Written and reviewed by the Assurance HVAC Heating & Cooling of Mississauga service team.

On this page
  1. Water heater installation in Mississauga: repair, or replace the tank?
  2. Side-splits and bungalows in Applewood, Erindale and Meadowvale
  3. Choosing between a tank and tankless in Mississauga
  4. Hot water in compact Churchill Meadows and Lisgar mechanical rooms
  5. Big rebuilds and older houses by the lake in Clarkson and Mineola
  6. Getting the hot water size right for your household
  7. Chimney, power vent, direct vent or electric?
  8. Thermal expansion and a dripping relief valve
  9. Owning or renting a water heater in Mississauga
  10. Water heater installation in Mississauga: from arrival to handover
  11. Parts we replace on Mississauga water heaters
  12. Water heater installation in Mississauga: cost factors
  13. Leaks, gas smells and CO alarms around the water heater
  14. Water heater installation questions from Mississauga homeowners

Water heater installation in Mississauga: repair, or replace the tank?

Start with where the trouble is. A pilot that won’t hold, a heater that won’t fire or lukewarm water from a tank under ten years old usually means a part. Water leaking from the tank body, rusty hot water from an older tank, or loud rumbling on a tank past ten years usually means it’s time for a new one.

Repair or replace: common situations in Mississauga homes
What’s happeningUsuallyWhy
Pilot keeps going out on a six-year-old tankRepairA thermocouple or a pilot cleaning normally fixes it
Relief valve drippingRepairOften pressure from thermal expansion, solved with an expansion tank
Puddle from the tank shellReplaceThe inner tank has failed and can’t be patched
Rust-tinted hot water, tank over 10 yearsReplaceCorrosion has worked through the lining
Hot water runs out since the family grewReplaceThe tank is too small for the household now
Tankless unit showing scale-related codesRepairDescaling restores flow

Side-splits and bungalows in Applewood, Erindale and Meadowvale

In the bungalows, back-splits and side-splits that went up across Applewood, Cooksville, Erindale, Erin Mills and Meadowvale, the water heater usually shares a lower-level utility room with the furnace. Replacing the tank there is often straightforward, but the venting deserves a careful look before anything is ordered.

Many of these houses are on their second or third furnace. If the latest one is high-efficiency and vents through the wall, the gas tank may be the last appliance on a chimney built for two, and its draft can suffer. We test it, then fit a liner or recommend a power-vented tank. If the furnace itself is due, see furnace installation in Mississauga.

Choosing between a tank and tankless in Mississauga

Tankless is the better fit for busy households with overlapping showers, owners staying for years and tight utility rooms where floor space matters. A tank suits moderate use, a tighter budget, or homes where the gas line would need a big upgrade. Both come in gas, and tanks also come in electric.

Storage tanks and tankless heaters compared
Point of comparisonStorage tankTankless
Hot water limitThe tank’s volume, then recovery timeNone within its flow rating
Years of service8 to 12About 20 with descaling
Space usedA floor footprint plus clearancesA wall-mounted unit
During a power outageA gas tank with a standing pilot keeps workingNeeds electricity to run
Install complexityLow for a like-for-like swapHigher, with gas line, vent and condensate drain work

Hot water in compact Churchill Meadows and Lisgar mechanical rooms

Townhomes and semis built from the 1990s on in Churchill Meadows and Lisgar often have compact mechanical rooms, with the furnace, water heater and laundry close together. Swapping a tank there is mostly about fitting the space and finding a vent route that respects shared walls and the neighbours’ windows.

Power-vented tanks and tankless units vent through a side or rear wall, and the vent end has to stay clear of windows, doors, the gas meter and air intakes, the neighbour’s included. Where a Mississauga condo corporation manages the exterior, we go over its rules with you before installing.

Big rebuilds and older houses by the lake in Clarkson and Mineola

In Port Credit, Mineola, Lorne Park and Clarkson, older houses on large treed lots sit beside custom homes that replaced the original bungalows. The older homes raise chimney and space questions, while the new builds bring big bathroom counts and long pipe runs, so the right heater looks very different from one lot to the next.

For larger rebuilds, a tankless unit or two, or a high-recovery tank, keeps up with several bathrooms, and recirculation shortens the wait at a far ensuite. In older houses heated by radiators, a combi boiler or a boiler-fed indirect tank can take over from the separate water heater; our boiler repair in Mississauga page explains both.

Getting the hot water size right for your household

A new heater in a Mississauga home should match the household’s busiest hour. We count how many showers run together, whether there’s a big tub, and how laundry and dishes fit around them, then choose a tank by its first-hour rating or a tankless unit by its flow at winter inlet temperatures. Oversizing just heats water you never use.

A basement apartment adds a second peak. Sharing one tank can work if the two households don’t shower at the same time; otherwise a larger heater, or a separate one for the suite, avoids cold showers on both floors.

Chimney, power vent, direct vent or electric?

The vent decides a lot. A natural-draft gas tank needs a chimney or metal vent sized and lined for it. A power-vented tank pushes exhaust through plastic pipe with a fan and needs an outlet. A direct-vent tank uses a sealed through-wall vent and no room air. Electric tanks skip venting but need a 240-volt circuit.

In Streetsville and Meadowvale Village, where historic cores keep older homes, a new vent on a street-facing wall may raise heritage questions, so check with the City of Mississauga (opens in a new tab) before we fix its location.

Thermal expansion and a dripping relief valve

When water heats, it expands, and if a check valve or pressure regulator keeps it from backing into the main, pressure rises in the tank. The relief valve may start to drip, and fittings and faucets wear faster. An expansion tank on the cold supply line solves it, and we check for the need on every installation.

We also make sure the relief valve discharge runs down toward the floor or a drain, and confirm that the valve opens and reseats.

Owning or renting a water heater in Mississauga

Whether to keep a rental or own your heater depends on your numbers and preferences, and only you can weigh them. Look at the tank’s age, how long you plan to stay and what your agreement says, then compare the payments ahead of you with a flat-rate price to buy and install.

Owning means you choose the type and size and arrange service when it’s needed, and our workmanship comes with a written warranty. If you’re unsure, ask for a purchase quote and read it beside your agreement. We don’t comment on rental terms, only on the heater and the installation.

Water heater installation in Mississauga: from arrival to handover

The technician arrives in the two-hour window we booked, with a text on the way. Gas, water and power are shut off, the old tank is drained and removed, and the new heater is set, connected, filled, lit and tested. A like-for-like swap in a Mississauga home is usually finished in that one visit.

  • Gas line connected with a sediment trap, every joint leak tested by a TSSA-certified gas technician
  • Vent assembled and draft or combustion confirmed with the burner running
  • Shut-off valve, expansion tank and relief valve line added where needed
  • Old tank carried out of the house and recycled
  • A walk-through of the cold water shut-off and the temperature setting

Parts we replace on Mississauga water heaters

The parts that fail most are the ones that light and control the burner. We replace thermocouples and flame sensors, igniters and gas control valves, swap worn anode rods, flush the sediment that makes a tank rumble, and descale tankless heat exchangers. You hear the diagnostic fee before we book and approve the repair price before work.

  • Thermocouple or flame sensor: the pilot or burner lights, then drops out
  • Igniter: clicking with no flame on electronic-ignition tanks
  • Gas control valve: the burner ignores the temperature dial
  • Anode rod: worn away, leaving the tank lining unprotected
  • Sediment: rumbling and a shrinking hot water supply
  • Tankless scale: error codes, swinging temperature or weak flow

Water heater installation in Mississauga: cost factors

Price depends on the heater type and size, the venting route, gas line and electrical work, code updates such as an expansion tank, and access. A side-split utility room, a townhome closet and a lakeside rebuild are different jobs, so we quote after seeing the house, as one flat price approved before work starts.

What changes the price of a new water heater in Mississauga
FactorHow it affects the job
EquipmentTank, power-vented, direct-vent or tankless, and its capacity
VentingReusing a sound, lined chimney is simpler than a new wall route
Gas lineTankless may need a bigger supply from the meter
ElectricalAn outlet for a power vent, or a 240-volt circuit for electric
Code itemsExpansion tank, shut-off and relief valve piping
Access and rulesTight rooms, finished basements and condo approvals

Leaks, gas smells and CO alarms around the water heater

If the tank is leaking, shut the cold water valve on its top so it can’t refill, turn the gas control to off or trip the breaker, and keep water away from outlets and the furnace. Call us next; we’re open 24/7. A small leak from the tank shell tends to grow, so don’t wait for it to stop on its own.

  • Smell gas: get out, leave switches alone, then call Enbridge Gas at 1-866-763-5427 from outside
  • CO alarm: everyone outside, then call 911

The Ontario Fire Code puts carbon monoxide alarms next to each sleeping area, and on every storey since January 1, 2026, in homes that have a fireplace, an attached garage or a fuel-burning appliance such as a gas water heater. Once everything is safe, send a repair request or call the Mississauga line on this page.

FAQ

Water heater installation questions from Mississauga homeowners

Is there room for a new water heater in a townhome mechanical room?

Almost always. Compact tanks, direct-vent models and wall-hung tankless units are all made for tight rooms. We measure the space, door widths and the vent route before quoting, and check condo corporation rules where they apply. In many Mississauga townhomes, a tankless unit frees enough floor space to make furnace service easier as well.

Our side-split’s water heater still vents up the chimney. Is that a problem?

Not by itself. A natural-draft tank on a properly sized, lined chimney works fine. The trouble starts when a high-efficiency furnace has moved off that chimney, leaving the tank alone in a flue built for more. Then the draft can weaken and exhaust can spill. We test the draft and fix it with a liner or a power-vented tank.

How long does a water heater replacement take in Mississauga?

A like-for-like tank swap usually takes part of a day, with the old tank drained, removed and recycled in the same visit. Moving to tankless, rerouting a vent or upgrading the gas line takes longer, and we tell you what to expect when we quote. If the right size is in stock, the swap can often happen the day you call.

Do I need an expansion tank with my new water heater?

You need one when the water supply can’t absorb expansion, usually because a check valve or pressure regulator stops water flowing back to the main. Without it, pressure climbs each time the heater runs and the relief valve may drip. We check your system during every water heater installation in Mississauga and add an expansion tank only where it’s needed.

Is buying better than renting if we might move in a few years?

Not necessarily. A purchase pays off over the years you use it, so a short stay changes the math. Read your agreement to see what it says about ending it, look at the tank’s age, and compare the two paths over the time you expect to stay. We’ll give you a flat-rate purchase price so the comparison uses real numbers, not guesses.

Can I get water heater installation in Streetsville or Port Credit?

Yes. We install tank and tankless water heaters across Streetsville, Port Credit, Lorne Park, Erindale, Cooksville, Malton, the City Centre and the rest of Mississauga, and in Oakville, Toronto and Vaughan nearby. Call the local number or send the form, and we confirm a two-hour arrival window and text you when the technician is on the way.

Why does my water heater make a popping noise?

Popping or rumbling usually comes from sediment on the bottom of a gas tank. Water trapped under the minerals boils as the burner heats it, and the noise follows. Flushing the tank can quiet it and recover some capacity. On an older tank with heavy buildup, flushing may not help much, and pricing a replacement is worthwhile.

What happens to my old water heater after it’s replaced?

When water heater installation in Mississauga is done, the old tank leaves with us: we drain it, carry it out of the house and send it for recycling, so you aren’t left with it in the garage or at the curb. If the tank is rented, read your agreement before the day so you know whether it needs to be kept for return, and tell us when you book.

Book a visit

Need water heater installation in Mississauga? We’ll call you back to book.

Send the form or call. You’ll get a confirmed arrival window and a price before any work starts.

(647) 492-6590

Open 24/7, with technicians out day or night for no-heat and no-cooling emergencies

Request a technician

Tell us what’s going on. We’ll call to confirm a time.

What do you need?
How soon? Optional
Add an email or detailsOptional

Or call (647) 492-6590Used only to book your visit. Privacy