
Emergency furnace repair in Richmond Hill
(647) 905-9241Open 24/7, day or night
When the heat quits in the middle of winter, call Assurance HVAC Heating & Cooling of Richmond Hill for emergency furnace repair in Richmond Hill. We provide 24-hour furnace repair, so emergency calls go to the front of the line ahead of everything routine, and a TSSA-certified gas technician comes out day or night to track down what stopped the furnace. You approve a flat-rate price before the work begins. For a furnace that still heats but is acting up, regular furnace repair in Richmond Hill is the better fit.
Key takeaways
- Open 24/7 in Richmond Hill, with a technician sent out day or night, weekends included.
- Emergency calls go to the front of the line, ahead of tune-ups and routine repairs.
- Every Richmond Hill call goes to a TSSA-certified gas technician, WSIB covered and insured.
- The repair price is flat and agreed before work starts, with a written workmanship warranty.
- Smell gas? Avoid switches and flames, leave, and call Enbridge Gas from outside. CO alarm? Get out, call 911.
Last updated . Written and reviewed by the Assurance HVAC Heating & Cooling of Richmond Hill service team.
On this page
- Emergency furnace repair in Richmond Hill: what counts?
- Gas smell or CO alarm in a Richmond Hill home? Get out first
- Furnace stopped working? Check these first
- How we handle emergency furnace repair in Richmond Hill
- What the technician checks first on a no-heat call
- Keeping your family warm and avoiding frozen pipes
- Snow, ice and frozen drains in a Richmond Hill winter
- No heat in a Richmond Hill townhome, condo or basement suite
- Emergency HVAC repair beyond the furnace
- Repair now or replace an older Richmond Hill furnace?
- What drives the price of emergency furnace repair in Richmond Hill?
- Avoiding the next Richmond Hill breakdown
- Technicians out day or night, from Oak Ridges to Langstaff
- Emergency furnace repair questions from Richmond Hill homeowners
Emergency furnace repair in Richmond Hill: what counts?
It’s a no-heat emergency when the furnace is out in freezing weather or someone at home can’t safely ride out the cold, and a safety emergency when there’s a gas smell, a carbon monoxide alarm, smoke or a hot electrical smell. For smoke or that burning smell, switch the furnace off at its service switch if it’s safe to reach. If there’s fire or heavy smoke, get out and call 911.
- The house is losing heat and the forecast is below zero
- A baby, an older relative or someone unwell at home as the rooms cool
- A smell like rotten eggs anywhere in the house
- A CO alarm, or headaches and nausea that ease outdoors: either way, get everyone out and call 911
- Smoke or a burning electrical smell from the furnace
A furnace that still puts out some heat can usually wait for a booked visit. So can a squeaky blower, one chilly bedroom or a rising gas bill.
Gas smell or CO alarm in a Richmond Hill home? Get out first
A gas smell or a sounding carbon monoxide alarm comes before any furnace repair. Get every person and pet outside without touching light switches, lighting a match or lighter, or using a phone indoors. Once you’re out, call Enbridge Gas at 1-866-763-5427 for gas, or 911 for a CO alarm. Call us about the furnace after the house is made safe.
- Don’t go back in to look at the furnace, even if the alarm goes quiet.
- Wait until the fire service or Enbridge says the house is safe to re-enter.
Ontario’s rules call for a carbon monoxide alarm beside every sleeping area, plus one on every storey since January 1, 2026, in homes with a fuel-burning appliance, a fireplace or an attached garage, and that covers every Richmond Hill home with a gas furnace. The province’s carbon monoxide safety page (opens in a new tab) shows where they go, and Enbridge’s gas safety pages (opens in a new tab) explain what to do about a gas smell.
Furnace stopped working? Check these first
If the furnace stopped working, spend a few minutes on causes you can fix yourself. A thermostat on the wrong mode, a furnace switch knocked off, a dust-packed filter or vent pipes buried by snow can each shut down a furnace with nothing wrong with it, and none of them needs a technician.
- Thermostat: Heat mode, a setpoint above room temperature and a working display.
- Power: the furnace’s switch on the wall or cabinet, and its breaker in the panel.
- Filter: one caked with dust can overheat the furnace until a safety switch stops it.
- Outside vents: on a high-efficiency furnace, clear snow and ice from the plastic vent pipes, usually two on a side wall.
- Drain: gurgling or water near the furnace in a deep freeze can mean an iced-up condensate line.
If that doesn’t bring the heat back, restart the furnace once at its switch. If it locks out again, leave it off and call, because a safety control is stopping it for a reason.
How we handle emergency furnace repair in Richmond Hill
Every call for emergency furnace repair in Richmond Hill is answered 24/7, and no-heat calls move to the front of the line ahead of tune-ups and routine repairs. We ask what the furnace is doing, walk you through any safety steps and tell you the diagnostic fee, and then a technician is sent out, whether it’s midnight or midday.
- Describe the symptom and any blinking light, and say how old the furnace is and which checks you’ve done.
- Mention anyone at home who is vulnerable to the cold.
- The technician finds the fault and quotes one flat-rate price for the repair.
- Once you approve, the repair is done, usually that visit if the part is on the truck, then tested through full heating cycles.
What the technician checks first on a no-heat call
On a no-heat call, the technician follows the furnace’s own start-up sequence: the thermostat’s call for heat, the inducer motor, the pressure switch, ignition, flame proving and then the blower. Wherever that sequence stops is where the fault lies, which keeps the diagnosis quick when you want the heat back.
| Where it stops | What you might notice | Likely fault |
|---|---|---|
| Nothing starts | The thermostat calls, but the furnace stays silent | Power, a board fuse or the control board |
| Inducer runs, no ignition | A hum, a click, then a lockout | Pressure switch, blocked vent or full condensate trap |
| Igniter stays dark | No orange glow through the sight window | A cracked hot surface igniter |
| Burners light, then go out | Flame for a few seconds, then quiet | A coated or worn flame sensor |
| Burners stay lit, no warm air | Heat builds but the rooms stay cold | Blower motor, capacitor or ECM module |
Keeping your family warm and avoiding frozen pipes
Until the technician reaches your Richmond Hill home, hold on to the heat you have and protect the plumbing. Gather everyone in one or two rooms with the doors closed, open the cabinets under sinks on outside walls and let a cold tap drip. Never heat the house with a gas stove or barbecue, and never run a generator or car in the house or an attached garage, since they can produce carbon monoxide.
- Close off unused rooms, but leave kitchens and bathrooms open so their pipes get house air.
- Keep electric space heaters a metre from bedding, curtains and furniture, plugged straight into the wall, and off while you sleep.
- Check a basement suite, a room over the garage or any space with plumbing on an exterior wall.
Snow, ice and frozen drains in a Richmond Hill winter
Plenty of winter shutdowns in Richmond Hill have nothing to do with a broken part. A high-efficiency furnace vents through plastic pipes, usually two on a side wall, and drains water from its exhaust, so snow drifting over those pipes, or a condensate line freezing in a cold space, can trip a safety switch and stop the heat.
In the newer subdivisions of Jefferson and Oak Ridges, and on two-storey streets in Rouge Woods and Westbrook, a condensing furnace with side-wall vents is likely. After a storm, check that the pipe ends aren’t buried, and don’t pile shovelled snow against that wall.
Older houses near Mill Pond and the remaining post-war homes in Richvale may still vent a mid-efficiency furnace into a chimney, where a blocked flue or weak draft is the likelier fault.
No heat in a Richmond Hill townhome, condo or basement suite
Townhomes and condos along Yonge Street and near Langstaff often heat with a compact furnace, a fan coil or a heat pump instead of a full-size furnace. We take no-heat calls on all of them. In a condo, the problem can sit with the building’s hot water supply or controls, so tell us the building type when you call.
With a basement apartment, tell us whether the suite shares the main furnace or has its own heat.
Emergency HVAC repair beyond the furnace
Our 24/7 Richmond Hill line covers more than furnaces. In Richvale and Bayview Hill, a number of custom homes run in-floor heat from a boiler, and when it stops, those floors lose their heat more slowly than forced air, but a cold night still gets through. If the boiler’s pressure gauge reads high or its relief valve is dripping, call us straight away.
A central air system that dies in a heat wave counts too, as a no-cooling emergency. More on radiant systems is on our boiler repair page.
Repair now or replace an older Richmond Hill furnace?
Often the fix is a single part, but on a furnace that age the honest answer is sometimes a replacement. That’s likely with a cracked heat exchanger, a furnace past 15 years that now needs an expensive component, or one that has failed winter after winter. You get both prices and our view before deciding.
If the furnace has to stay off for safety, we make the gas and venting safe and price the replacement with you. Our page on furnace installation in Richmond Hill explains sizing and what installation day involves.
What drives the price of emergency furnace repair in Richmond Hill?
The cost of a no-heat call depends on the part that failed, whether it’s on the truck, the furnace’s brand and age, how easy the furnace is to reach and whether a second problem caused the first. You hear the diagnostic fee before we book, and you approve one flat repair price before anything is done.
| Factor | Why it matters |
|---|---|
| The failed part | Cleaning a flame sensor is quick. Replacing a blower motor or circuit board takes longer and costs more in parts. |
| Root cause | A pressure switch that tripped because the drain froze needs the drain fixed too. |
| Part availability | Common parts travel with the technician. A part made for one brand may need ordering. |
| Age and model | Parts for older or less common furnaces can be harder to source. |
| Getting to the furnace | Finished basements and closet installs take longer to work in. |
The price you agree to is the one you pay, however long the repair runs.
Avoiding the next Richmond Hill breakdown
Cold-weather breakdowns rarely come from nowhere. A weakening capacitor, an igniter near the end of its life or a drain trap filling with sludge usually gives some warning, and a tune-up before the heating season finds it in daylight, on your schedule, instead of during the first deep freeze.
A fall furnace maintenance visit cleans and tests those parts and checks the venting. No provincial law requires it, but many furnace warranties ask for service records, so check what yours says. On the maintenance plan, both yearly tune-ups are scheduled for you, and members get priority booking in busy weeks.
Technicians out day or night, from Oak Ridges to Langstaff
We provide emergency furnace repair in Richmond Hill wherever you live, with 24-hour furnace repair for Oak Ridges, Jefferson, Crosby, North Richvale, Richvale, Mill Pond, Bayview Hill, Doncrest, Devonsleigh, Rouge Woods, Westbrook and Langstaff, and for nearby Markham, Vaughan and North York.
See our HVAC contractor in Richmond Hill page for local homes and systems.
Emergency furnace repair questions from Richmond Hill homeowners
Can I get 24-hour furnace repair in Richmond Hill in the middle of the night?
Yes. We’re open 24 hours a day, so a no-heat call at 2 a.m. goes to the front of the line ahead of routine bookings, and a technician comes out that night. Expect a few questions about the symptoms and who is home first. A gas smell comes before everything: leave without touching switches, flames or your phone, and call Enbridge Gas at 1-866-763-5427 from outside.
Does your emergency furnace repair cover all of Richmond Hill?
Yes. Call the local number on this page or send the request form, which goes to our Richmond Hill line. We take no-heat calls from Oak Ridges and Jefferson to Langstaff and Doncrest, and in nearby Markham, Vaughan and North York. Every one is answered 24/7 and handled by a TSSA-certified gas technician.
What if my furnace keeps locking out?
A furnace lockout means a safety control stopped the burners, often after several failed attempts to light. One restart at the furnace switch is reasonable once you’ve checked the filter, thermostat and vents. If it locks out again, leave it off. More restarts won’t fix the fault and can clear the error code the technician would use.
Can a frozen vent or drain stop my furnace?
Yes, especially after a Richmond Hill snowstorm. On a high-efficiency furnace, an intake or exhaust pipe blocked by snow, or a condensate line frozen solid, trips the pressure switch and the furnace shuts down to stay safe. Brush the outside pipe ends clear by hand. If the drain runs through a cold garage or crawl space, it may need insulating or rerouting.
Can a Richmond Hill no-heat repair usually be done in one visit?
Often, yes. Common parts ride along on the truck, so a failed igniter, flame sensor or capacitor can usually be replaced that visit. Brand-specific control boards or ECM modules sometimes have to be ordered. If so, you’ll know before approving the repair, along with what can be done to keep the house safe meanwhile.
What should I do if the CO alarm goes off but nobody feels sick?
Treat it as real. Get everyone outside, pets included, and call 911 from there. Carbon monoxide has no smell or colour, so feeling fine doesn’t mean the air is safe. Once responders have checked the house, call us to inspect the furnace, the water heater and their venting, since any fuel-burning appliance can be the source.
Why do furnaces seem to fail on the coldest night?
A Richmond Hill cold snap keeps a furnace firing almost nonstop, so a part that was already weak, like a tired capacitor, a worn igniter or an aging inducer motor, finally gives out. Snow and ice add their own trouble by covering vent pipes and freezing condensate lines. A fall tune-up catches much of that wear before winter.
What happens if the furnace can’t be fixed on the first visit?
If a part has to be ordered or the furnace is unsafe to run, the technician explains why and what comes next. A furnace with a cracked heat exchanger stays off. You get a flat-rate price for the repair or a replacement, and we go over how to keep the house and pipes safe in the meantime.
Need emergency furnace repair in Richmond Hill? We’ll call you back to book.
Send the form or call. You’ll get a confirmed arrival window and a price before any work starts.
Open 24/7, with technicians out day or night for no-heat and no-cooling emergencies
